• Operating manual Also for models with natural refrigerants Valid for: K12-cc-NR, K15-cc-NR, K20-cc-NR, K25-cc-NR, K6-cc, K6s-cc-NR variostat cc ministat 125-cc, ministat 125w-cc ministat 230-cc, ministat 230w-cc ministat 240-cc, ministat 240w-cc CC-405, CC-405w, CC-410wl, CC-415, CC-415wl CC-505, CC-505wl, CC508, CC-510, CC-510w, CC-515, CC-515w. • Contents V2.2/09.11 // software V06.10.001 Foreword...4 Quick guide for CC-thermostats..5 Chapter 1: Safety...7 Description of Safety and Information symbols..8 Intended Use and General Safety Instructions..9 Description... 10 Duties of responsible person..11 Operator requirements..11 Machine operator duties.. • Ending CC Temperature control..67 Filling and air purging an externally closed system.68 Draining the machine and an externally closed application.69 Changing thermal fluid / internal cleaning..

69 Chapter 4: Interfaces..70 Interface modules (RS232/SERIAL, Com.G@te and Web.G@te) and Interface menus. 71 RS232/SERIAL... • Foreword Dear Customer, The Huber team would like to thank you for ordering this product.

Huber Unistat 510 with Pilot ONE: Dynamic temperature control system / circulation thermostat. View and Download Huber K12-cc-NR operating manual online. Thermostat Huber unistat cc401 Operating Manual. 415wl CC-505, CC-505wl, CC508, CC-510, CC-510w.

You have made a good choice. Need Speed Underground 2 Game Demo. We thank you for your trust!

Please read and understand the instruction manual thoroughly before operating the unit. All instructions and safety information must be complied with. • Quick guide for CC-thermostats Checklist for initial operation: 1. Make sure that the machine is connected correctly and enough thermal fluid is inside. Switch on the unit via the mains switch! Make sure that the over-temperature is set correctly. • COM.G@TE allocation and setting (quick guide) POCO (potential free contact) Alarm plug-in connector Signal contact for external monitoring.

The connection is designed as a potential free changeover contact. Normally open contact between pin 1 and pin 2. Normally closed contact between pin 2 and pin 3. Contact load: 1A at 24V DC Only use screened lines! AIF Reg-E-Prog Socket Analogue interface, one input channel (programmable) and 3 output channels.

• Chapter 1: Safety In this chapter is to be found the following sections: Description of safety and information symbols Intended use and General Safety Information Description Duties of the responsible person Operator requirements Machine operator duties Work area Safety Devices to DIN 12876 (applicable for units with heating) Additional Protection Devices (if provided) Environmental conditions Operating conditions. • Description of Safety and Information symbols Safety information is shown with a pictogram and keyword.

The keyword indicates the level of the corresponding danger. Immediate risk to the life and health of Danger!

Personnel (Serious injury or death). Oovoo Crack. Possible risk to the life and health of Warning! Personnel (Serious injury or death). • Intended Use and General Safety Instructions Danger! Non-intended use can result in considerable personal injuries and material damage. No third persons are authorized to make any changes to the machine. The device declaration becomes void, if any modification is carried out without manufacturers consent.

• Description These temperature control machines have been designed to be used with either external closed systems (e.g. Jacketed reactors) or the internal bath. For temperature control devices with compressor cooling, the low internal volume combined with high performance refrigeration and heating technology, gives a very short cooling and heating time compared with conventional bath technology. • Duties of responsible person The operating instruction is to be kept easily accessible and in immediate vicinity of the unit. Only suitably qualified personnel should operate this unit. Personnel should be properly trained before operating the unit.